cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
berker_atel
Adventurer
Adventurer
780 Views
Registered: ‎11-09-2016

VDMA delay between frames

Jump to solution

Hi,

I configured VDMA as Fsycn=None and Lockgen=Master. Also video parameters:

HSIZE=200byte

STRIDE=200byte

VSIZE=4line

FrameCount=3

How can i control delay between frames? Or should i change Fsync to tuser similar options for control it.  

vdma2.png

Second question: When 8bit AXIS is used, there is no delay between lines. You can see low level tvalid signal in the figure. But with 16bit AXIS, there is a 2-3 clocks delay. Why? How can i remove this delay? 

Thanks

 

 

 

 

Tags (2)
0 Kudos
1 Solution

Accepted Solutions
berker_atel
Adventurer
Adventurer
531 Views
Registered: ‎11-09-2016

Sorry, I' forgot. I reply. A delayed reply better than nothing. 

I wanted to send a test image to VGA screen directly without writing any logic. For this i used to need matching blanking intervals. 

Now i do it with controlling tready of VGA logic. I'm doing tready low during blanking intervals. I think this way is better. 

 

 

View solution in original post

3 Replies
florentw
Moderator
Moderator
706 Views
Registered: ‎11-09-2015

HI @berker_atel 

I am not sure if you can improve this. If you check the figure 2-1 in pg020 you will see that there is a delay between 2 frames.

Is there a reason why you need to change this? In nost video system you have the blanking period on the native interface so this delay is not much and won't be seen at the output

Regards


Florent
Product Application Engineer - Xilinx Technical Support EMEA
**~ Don't forget to reply, give kudos, and accept as solution.~**
0 Kudos
aoifem
Moderator
Moderator
670 Views
Registered: ‎11-21-2018

Ho @berker_atel 

Do you have any update on this?

Regards,

Aoife
Product Application Engineer - Xilinx Technical Support EMEA


**~ Got a minute? Answer our Vitis HLS survey here! ~**

**~ Don't forget to reply, give kudos, and accept as solution.~**
0 Kudos
berker_atel
Adventurer
Adventurer
532 Views
Registered: ‎11-09-2016

Sorry, I' forgot. I reply. A delayed reply better than nothing. 

I wanted to send a test image to VGA screen directly without writing any logic. For this i used to need matching blanking intervals. 

Now i do it with controlling tready of VGA logic. I'm doing tready low during blanking intervals. I think this way is better. 

 

 

View solution in original post