UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Visitor matteric
Visitor
490 Views
Registered: ‎08-09-2017

Error in project migration from sdaccel 2017.1 to sdaccel 2017.4.op and 2018.2

Jump to solution

Hi,

 

I am working on migration one project from sdaccel 2017.1 to the new version of 2017.4.op and 2018.2. 

under sdaccel 2017.1 env, the hardware simulaiton and deploy-test on board are successfully. But,

under sdaccel 2017.4.op, there is no valid data for signal s_axi_control_awaddr (axi-lite interface) in the hardware simulation, and the generated xclbin file can not feedback results when on-board test;

under sdaccel 2018.2, the following error is reported in the hardware simulation:

 

./xsim.dir/emu_wrapper_behav/axsim:symbol lookup error: ...../.run/162638/hw_em/device0/binary_0/behav_gdb/xsim/libdpi.so : undefined symbol: _ZN12xcl_api_respC1Ev

simulation engine can not start, code 127

 

Thanks,

Matt

0 Kudos
1 Solution

Accepted Solutions
Xilinx Employee
Xilinx Employee
455 Views
Registered: ‎07-16-2008

回复: Error in project migration from sdaccel 2017.1 to sdaccel 2017.4.op and 2018.2

Jump to solution

Different SDx releases support different built-in DSAs. Did you target the same DSA? If not, did you run xbinst to install the driver, firmware and runtime libraries for the new DSA?

 

With regards to the simulation error in 2018.2, how is environment variable $LD_LIBRARY_PATH set?

-------------------------------------------------------------------------
Don't forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------

View solution in original post

1 Reply
Xilinx Employee
Xilinx Employee
456 Views
Registered: ‎07-16-2008

回复: Error in project migration from sdaccel 2017.1 to sdaccel 2017.4.op and 2018.2

Jump to solution

Different SDx releases support different built-in DSAs. Did you target the same DSA? If not, did you run xbinst to install the driver, firmware and runtime libraries for the new DSA?

 

With regards to the simulation error in 2018.2, how is environment variable $LD_LIBRARY_PATH set?

-------------------------------------------------------------------------
Don't forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------

View solution in original post