UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Visitor tomjames
Visitor
425 Views
Registered: ‎01-15-2019

SD Card boot files generated by SDSoC cannot work correctly

Jump to solution

Hi,

I'm using the SDx 2018.3 and 60 days evaluation license and ZedBoard. My PC system is Ubuntu 18.04. I tried to go through the example Lab1 in UG1028:

https://www.xilinx.com/support/documentation/sw_manuals/xilinx2017_1/ug1028-sdsoc-intro-tutorial.pdf

I encountered several problems:

1. I didn't see "File→New→Xilinx SDx Project" option. Instead, I only selected "File→New→SDx Application Project" to create Lab1. I don't know whether it is correct.

2. The "Options" in "lab1" table is not the same as shown in the tutorial:

Screenshot from 2019-03-20 20-29-02.png

There is no "Generate bitstream" option which is in the tutorial:

Screenshot from 2019-03-20 20-30-54.png

I'm wandering whether this will affect the completeness of generating boot files which should be stored into the sd card.

3. After build, I copied all the files under the sd card folder to the sd card:

Screenshot from 2019-03-20 20-35-33.png

I set the zedboard to sd card boot mode. But the Linux didn't start up and there is nothing in the opened terminal. The "DONE" LED didn't give out light. LD9 and POWER are lit. 

Can anyone help me out of these problems? I will appreciate it very much if anyone can help me!

0 Kudos
1 Solution

Accepted Solutions
Visitor tomjames
Visitor
284 Views
Registered: ‎01-15-2019

Re: SD Card boot files generated by SDSoC cannot work correctly

Jump to solution

Sorry for the late reply. I successfully made it work just by choosing the platform as "zed" instead of "ZC702". I'm using a zedboard.

View solution in original post

0 Kudos
2 Replies
Moderator
Moderator
365 Views
Registered: ‎08-20-2018

Re: SD Card boot files generated by SDSoC cannot work correctly

Jump to solution

Hi @tomjames 

Please refer below tutorial and try.

https://github.com/Xilinx/SDSoC-Tutorials

Best Regards,
Nutan
-------------------------------------------------------------------------------
Please don't forget to reply, kudo and accept as a solution
0 Kudos
Visitor tomjames
Visitor
285 Views
Registered: ‎01-15-2019

Re: SD Card boot files generated by SDSoC cannot work correctly

Jump to solution

Sorry for the late reply. I successfully made it work just by choosing the platform as "zed" instead of "ZC702". I'm using a zedboard.

View solution in original post

0 Kudos