UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Participant leonardo_suriano
Participant
2,432 Views
Registered: ‎01-13-2017

SDSoC profiling: hardware + software event tracing

Jump to solution

Following the tutorial and the user guide UG1027 and UG1028, it is possible to create an application and profile it thanks to the "event tracing" option.

Then, the Gantt chart shows only the events related to the hardware calls, execution, control commands...of the hardware IPs on the PL. This operation is possible because of some blocks inserted in the "design block" by Vivado SDSoC, directly connected with the AXI interfaces used to exchange data with the PS.

It would be greate to have the possibility of profiling both, hw + sw, at the same time and to visualize the results on the same Gantt chart. Is there a possibility of doing that?

So far, as I said, only hw profiling was possible.

If you need more details on the project I can update the question.

 

Regards

Tags (2)
0 Kudos
1 Solution

Accepted Solutions
Observer wsun
Observer
4,408 Views
Registered: ‎05-26-2016

Re: SDSoC profiling: hardware + software event tracing

Jump to solution
For SW profiling, there are a lot of choices. Please refer to SDSoC documentation for "TCF Profiling".
0 Kudos
1 Reply
Observer wsun
Observer
4,409 Views
Registered: ‎05-26-2016

Re: SDSoC profiling: hardware + software event tracing

Jump to solution
For SW profiling, there are a lot of choices. Please refer to SDSoC documentation for "TCF Profiling".
0 Kudos