UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!
Help
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
ajcrm125
Adventurer
Adventurer

‎07-17-2013 01:29 PM

7,667 Views
Registered: ‎06-04-2010

Chipscope cores show up on V4 device but not V2 device

I'm using ChipScope through Labtools 14.5. I have a dev board with a V4 and V2 on it. In both the V4 and V2 designs, I have ICON and ILA cores instantiated. Both synthesize and map fine (from what Ican tell). However when I use Chipscope on the board it identifies with the V4 and trhe V2 but only shows the Chipscope cores within the V4 device. The scan chain doesn't identify any chipscope cores within the V2 device.. Something I may be missing?

0 Kudos
Reply
1 Reply
debrajr
Moderator
Moderator

‎07-28-2013 12:09 AM

7,638 Views
Registered: ‎04-17-2011

Re: Chipscope cores show up on V4 device but not V2 device

Where you able to see the chain in IMPACT properly?
Are you seeing messages as : "INFO: Found 0 Core Units in the JTAG device Chain"? If yes, Refer: http://www.xilinx.com/support/answers/19337.htm
Regards,
Debraj
----------------------------------------------------------------------------------------------
Kindly note- Please mark the Answer as "Accept as solution" if information provided is helpful.

Give Kudos to a post which you think is helpful and reply oriented.
----------------------------------------------------------------------------------------------
0 Kudos
Reply