UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Participant rs2015
Participant
3,156 Views
Registered: ‎09-17-2014

Serial IO Analyzer Sweep Parameter entry problem

I am using the Vivado 2015.4 Serial IO Analyzer.

 

I would like to perform a sweep to vary the RXCDR_CFG parameter, which is an 18 digit hex number (72 bits).

 

However, I get the following error:

 

invalidhex2.JPG

 

But this is the default value that the tool shows:

 

invalidhex1.JPG

 

 

 

0 Kudos
2 Replies
Moderator
Moderator
3,115 Views
Registered: ‎02-16-2010

Re: Serial IO Analyzer Sweep Parameter entry problem

What is the reason for this test? can you get the required setting for RXCDR_CFG from GT wizard?
------------------------------------------------------------------------------
Don't forget to reply, give kudo and accept as solution
------------------------------------------------------------------------------
0 Kudos
Participant rs2015
Participant
3,110 Views
Registered: ‎09-17-2014

Re: Serial IO Analyzer Sweep Parameter entry problem

We're having trouble with PHY errors on our SATA port.  I'm investigation the configuration's effect.

 

I found a work-around:

1. create a sweep with one parameter, such as RXTERM

2. right-click on sweep and select properties

3. Under the PROPERTIES tab, select ITERATION_SETTINGS and enter the sweep parameters, e.g.

 

{DRP.RXCDR_CFG  0388008BFF40100008} {DRP.RXCDR_CFG  03800023FF40200020} {DRP.RXCDR_CFG  03800023FF10400008}

0 Kudos