cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Highlighted
Contributor
Contributor
8,497 Views
Registered: ‎09-23-2014

Vivado 2014.3 - "Go to source" in schematic view broken

Hi,

 

after upgrading from 2013.4 to 2014.3, the "Goto source" function in Schemaitc view is broken, i.e. gone from the menues and not avaiable via the F7 key. The same is true for the net list where that function used to work.

 

I'm opening checkpoints (post place and post route) built with 2014.3, but not in project mode.

 

I loved this feature, is there a workaround?

 

Thanks,

Mike

Tags (1)
0 Kudos
1 Reply
Highlighted
Xilinx Employee
Xilinx Employee
8,181 Views
Registered: ‎04-16-2012

Hello @mike_east 

 

I observe the option "Go to Source" when right-clicking on any cell of schematic. See snapshot below:

synth_source.PNG

 

When opening design checkpoint (i.e., .dcp) file, I do not observe the "Go to source" option, since the tool do not know where the source files are located.

 

Thanks,

Vinay

--------------------------------------------------------------------------------------------
Have you tried typing your question in Google? If not you should before posting. Also, MARK this is as an answer in case it helped resolve your query/issue.Give kudos to the post that helped you to find the solution.
0 Kudos