cancel
Showing results for 
Search instead for 
Did you mean: 
Anonymous
Not applicable
7,792 Views

a chipscope problem

Jump to solution

hello,I have a question with using chipscope.

 I open the cable and search JTAG chain , download the bit file successfully.The problem is that the ILA can not be opened at all.Nothing appears and i can not find the signals to analyze.I remember that the ILA should be started automatically.I do not know the reason.

chipscope1.jpg
0 Kudos
1 Solution

Accepted Solutions
Highlighted
Moderator
Moderator
15,170 Views
Registered: ‎07-01-2015

Re: a chipscope problem

Jump to solution

Hi @Anonymous,

 

Please go through following document to verify if something is missing

http://www.xilinx.com/support/documentation/sw_manuals/xilinx14_4/ug750.pdf

 

Thanks,
Arpan

Thanks,
Arpan
----------------------------------------------------------------------------------------------
Kindly note- Please mark the Answer as "Accept as solution" if information provided is helpful.

Give Kudos to a post which you think is helpful and reply oriented.
----------------------------------------------------------------------------------------------

View solution in original post

0 Kudos
3 Replies
Highlighted
Moderator
Moderator
15,171 Views
Registered: ‎07-01-2015

Re: a chipscope problem

Jump to solution

Hi @Anonymous,

 

Please go through following document to verify if something is missing

http://www.xilinx.com/support/documentation/sw_manuals/xilinx14_4/ug750.pdf

 

Thanks,
Arpan

Thanks,
Arpan
----------------------------------------------------------------------------------------------
Kindly note- Please mark the Answer as "Accept as solution" if information provided is helpful.

Give Kudos to a post which you think is helpful and reply oriented.
----------------------------------------------------------------------------------------------

View solution in original post

0 Kudos
Highlighted
Anonymous
Not applicable
7,784 Views

Re: a chipscope problem

Jump to solution

Thank you very much for your reply.

The problem occurs today.The ILA is functioning well yesterday and I have been using this ISE version on this PC for several months,so I think the software is installed successfully and.What is more, i do not remember any change about the settings.Quite confused

0 Kudos
Highlighted
Moderator
Moderator
7,721 Views
Registered: ‎07-01-2015

Re: a chipscope problem

Jump to solution

Hi @Anonymous,

 

Is it the same design that was working previously?

 

If so are you getting any warning message?

 

Thanks,
Arpan

Thanks,
Arpan
----------------------------------------------------------------------------------------------
Kindly note- Please mark the Answer as "Accept as solution" if information provided is helpful.

Give Kudos to a post which you think is helpful and reply oriented.
----------------------------------------------------------------------------------------------
0 Kudos