cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Highlighted
Voyager
Voyager
1,003 Views
Registered: ‎10-12-2016

write_debug_nets command data into file but that ltx file does not has net names ?

Jump to solution

Hi Friends,

 

After generating bit file , i open debug.ltx file from the runs folder but that file does not has net names , please find the attachment. 

 

 

Any help or suggestions are highly appreciated.

 

Thank you 

S Sampath 

-Sampath
Tags (1)
ltxfile_net_names_issue.png
0 Kudos
Reply
1 Solution

Accepted Solutions
Highlighted
Moderator
Moderator
1,161 Views
Registered: ‎10-19-2011

You could also try mark_debug for the nets you selected to debug. This will add some keep constrains so the net names get preserved. This is talked about in UG908.

-------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------

View solution in original post

0 Kudos
Reply
2 Replies
Highlighted
Moderator
Moderator
947 Views
Registered: ‎02-09-2017

Hi @ssampath,

 

How are you connecting those nets to the ILA and VIO? Did use the mark debug attribute on HDL level, or did you open the synthesized design and right-click the nets and selected "mark for debug"?

 

Can you try to open the synthesized design (with the ILA and VIO already implemented) and run the command write_debug_probes C:/<your_location>/designProbes.ltx and check if the generated file is correct?

 

Thanks,

Andre Guerrero

Product Applications Engineer

-------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------
0 Kudos
Reply
Highlighted
Moderator
Moderator
1,162 Views
Registered: ‎10-19-2011

You could also try mark_debug for the nets you selected to debug. This will add some keep constrains so the net names get preserved. This is talked about in UG908.

-------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------

View solution in original post

0 Kudos
Reply