cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Highlighted
Explorer
Explorer
1,877 Views
Registered: ‎10-12-2018

Memory read error at xxx. Timeout waiting for the Instruction Complete bit

Jump to solution

I just want to share my experience.

The issue

I got the following error message in my XSCT TCL console, during reading couple of registers of my new peripheral:

 

Memory read error at xxx. Timeout waiting for the Instruction Complete bit

This error message comes after reading 4-8 registers. It was NOT deterministic.

Solution

The rootcause was (in my case) that rready AXI-Lite signal wasn't connected from the PS to the peripheral. When I connected that signal too I could read consecutively as many registers as I want.

I use:

  • Vivado 2017.4
  • Win 10
  • Custom board
  • xc7z030 (Zynq)

 

1 Solution

Accepted Solutions
Highlighted
Explorer
Explorer
1,866 Views
Registered: ‎10-12-2018

Solution

The rootcause was (in my case) that rready AXI-Lite signal wasn't connected from the PS to the peripheral. When I connected that signal too I could read consecutively as many registers as I want.

View solution in original post

1 Reply
Highlighted
Explorer
Explorer
1,867 Views
Registered: ‎10-12-2018

Solution

The rootcause was (in my case) that rready AXI-Lite signal wasn't connected from the PS to the peripheral. When I connected that signal too I could read consecutively as many registers as I want.

View solution in original post