10-29-2015 06:15 AM
I tried to install the driver for xilinx programmer DLC9G but failed.
it shows the error as "A service installation section in this INF is invalid "
after searching the Xilinx forum regarding the same " AR# 31397 " i tried to follow the steps as metioned in the xilinx forum(to install drivers manually from command line using admin privilage) yet it shows the error as "cannot open service control manager"
thanks and regards
10-29-2015 06:23 AM
Try following the same procedure i.e., AR#31397 by downloading the drivers from the link: http://www.xilinx.com/support/documentation/user_guides/ug344.pdf
Also which OS are you using?
10-29-2015 06:37 AM
Yeah ug344 i followed ug344.pdf
i downloaded "ug344_windows.zip" and extractred in which i double clicked on "install_xusb.bat" to install the driver the driver was installed successfully.
then i plugged the USB cable to windows 7(64 bit ) again it stars installing the driver and shows the error message
"Device driver was not installed successfully"
My doubt is i already installed a driver again windows is checking the driver.
10-29-2015 07:49 AM
In the device manager can you see the Jungo drivers?
Can you try uninstalling and installing the drivers from the command prompt?
Please follow the below steps.