Help
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 
ganeshpatel
Adventurer
Adventurer

‎03-17-2017 02:23 AM

2,436 Views
Registered: ‎11-18-2016

No detection of xc7z030-2fg484i

I am using zynq xc7z030-2fg484i in our design. Device is not detecting in cascaded Jtag mode.  I checked power on sequence, POR and voltage levels and its ramp times.

 

  1. The voltages are all with in the operating limits.
  2. Power on reset is proper ie. Por is asserting 100milli seconds after vcco power good .
  3. Voltage Ramps with in the range of 200micro seconds to 50 milli seconds observed 24 mill seconds.
  4. Configuration is in cascaded Jtag mode.     
    •   all the above 1,2,3&4 points are observations. but while dumping program in to FPGA (using vivado16.3) nothing is detecting in "hardware manager". 
    • please review the schematics and suggest if anything wrong...

Thanks and Regards

Kasarla Ganesh

 

Preview file
434 KB
0 Kudos
1 Reply
balkris
Xilinx Employee
Xilinx Employee

‎03-17-2017 04:14 AM

2,419 Views
Registered: ‎08-01-2008

This ARs may be useful for debugging this issue
https://www.xilinx.com/support/answers/52538.html
Thanks and Regards
Balkrishan
--------------------------------------------------------------------------------------------
Please mark the post as an answer "Accept as solution" in case it helped resolve your query.
Give kudos in case a post in case it guided to the solution.
0 Kudos