04-24-2014 08:46 PM
i have a design in xilinx and i want to export the design into another software where i can test the design with analog circuit components. pls provide any softwares where i can do this.
04-24-2014 08:59 PM
04-24-2014 10:48 PM
04-24-2014 10:53 PM
04-24-2014 10:59 PM
so you might want to check ni.com for FPGA support.
They offer a lot of things, but not neccessarily a pure software solution.
And you probably need to spend a little fortune for the HW/SW and licenses.
I'm not familiar with the Labview environment, but it surely can create (text) files from your simulation results.
Maybe you can create a HDL-testbench that reads in these files as stimuli and does the logic simulation.
Or vice versa, if the analog stuff is connected to the outputs of the FPGA.
Only a closed loop simulation will be quite difficult (while not impossible).
Our students have done similar things with the matlab environment (so they could avoid using sysgen), but it depends quite a lot on the complexity of your design.
Have a nice simulation