UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Visitor fpga_choi
Visitor
302 Views
Registered: ‎06-10-2019

About Board ZCU102 Revision 1.1

Jump to solution

Lab bought two new ZCU102 boards, revision 1.1. We use SDSoC to develop, but there seems a problem that the BSP on SDSoC (2018.2) doesn't support this board. When I tried to boot, it was stuck at FSBL. Where I can get the BSP for SDSoC design? I found that the official page only has Rev 1.0. I've spent days on these new boards...截屏2019-11-14下午4.50.53.png

0 Kudos
1 Solution

Accepted Solutions
Highlighted
Xilinx Employee
Xilinx Employee
262 Views
Registered: ‎07-11-2019

Re: About Board ZCU102 Revision 1.1

Jump to solution

Hello @fpga_choi 

I have attached a link to a forum post that I think you will find very useful. 

Forum: https://forums.xilinx.com/t5/Xilinx-Evaluation-Boards/About-SDK-HelloWord-on-ZCU102-Rev-1-0-amp-1-1/td-p/940507

I hope this helps! 

-------------------------------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------------------------------

View solution in original post

0 Kudos
2 Replies
Highlighted
Xilinx Employee
Xilinx Employee
263 Views
Registered: ‎07-11-2019

Re: About Board ZCU102 Revision 1.1

Jump to solution

Hello @fpga_choi 

I have attached a link to a forum post that I think you will find very useful. 

Forum: https://forums.xilinx.com/t5/Xilinx-Evaluation-Boards/About-SDK-HelloWord-on-ZCU102-Rev-1-0-amp-1-1/td-p/940507

I hope this helps! 

-------------------------------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------------------------------

View solution in original post

0 Kudos
Visitor fpga_choi
Visitor
190 Views
Registered: ‎06-10-2019

Re: About Board ZCU102 Revision 1.1

Jump to solution

I solved this problem by using a new version of BSP, say 2018.3. Although the information shown was not exactly correct (still Rev1.0), it could boot anyway, and I don't know if there are some problems because of this.

Thank you!

0 Kudos