Hello to the community,
I am trying to run the webserver demo described in "UG668" without success. I set the jumpers, dip switches and network settings according to the document. All I see is the BIST coming up with its menu. The BIST runs ok, but where is the webserver? I cannot connect to the board (IP: 192.168.1.10). Is the webserver demo runnning in parallel to the BIST?
I spend quit some time on that, reading several forum entries about that topic but without finding a solution for this maybe simple out-of-the-box demo.
network setup:
my IP: 192.168.1.100
my network mask: 255.255.255.0
board IP: 192.168.1.10
board and pc connected with the included ethernet cable.
thanks for your support
claus
my hardware:
ML605 REV D
Virtex 6 CES
512MB DRAM / 2GB CF