cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
bhavanithya
Adventurer
Adventurer
1,514 Views
Registered: ‎06-04-2019

Problem with Hardware Co-Simulation for ZCU111 board

Hello Everyone,

I am trying to do hardware co-simulation (Simulink and ZCU111 Xilinx Board) using System Generator. When I select the board as "Zynq UltraScale+ ZCU111 Evaluation Platform Rev", the hardware co-simulation options for the compilation is disabled as seen in the below snapshot.

 

hwcosim.PNG

I observed for ZCU102 Zynq board it seems to be enabled only for JTAG,

hwcosim_zcu102.png

Do anyone know what is the reason. Does ZCU111 board not support Hardware co-simulation ?

Any inputs are really appreciated. Thanks!

Additional Information:

Matlab Version:  2019.1

Vivado Version: 2019.1

System Generator version: 2019.1

Thanks,
Bhavanithya Thiraviaraja
-------------------------------------------------------------------------------
Please Kudo or Accept as a solution, if this post helped you.
--------------------------------------------------------------------------------
Tags (2)
0 Kudos
2 Replies
andresb
Xilinx Employee
Xilinx Employee
1,477 Views
Registered: ‎06-21-2018

Hi Bhavanithya,

This is our User Guide on Hardware Co-Simulation:

https://www.xilinx.com/support/documentation/sw_manuals/xilinx2019_1/ug897-vivado-sysgen-user.pdf

This Mathworks page has the list of boards supported:

https://www.mathworks.com/help/hdlverifier/gs/supported-eda-tools.html

Maybe this is a way of adding support for your board?:

https://www.mathworks.com/help/hdlverifier/ug/what-is-fpga-board-customization.html

Thanks,
Andres

 

0 Kudos
bhavanithya
Adventurer
Adventurer
1,454 Views
Registered: ‎06-04-2019

Hello Andre,

Thank you for your response. I checked the links, it seems that ZCU111 board is not available in the FPGA Board manager after installing HDL coder and HDL Verifier for Xilinx Zynq devices. I tried to create a custom board but my device xczu28dr-2-effvg1517 is not present under the category Zynq Ultrascale+.

Is it possible to add the board from file..but the board fle in the Vivado installation folder is not compatible with the format expect by the FPGA Board Manager in Simulink. I am using MATLAB 2019.1 and I am not sure why Simulink do not support ZCU111 board. Can you please give me some insights on how to proceed now? 

 

Thanks,
Bhavanithya Thiraviaraja
-------------------------------------------------------------------------------
Please Kudo or Accept as a solution, if this post helped you.
--------------------------------------------------------------------------------
0 Kudos