cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
506 Views
Registered: ‎02-01-2020

System Monitor and GUI Interface

Jump to solution

Hi,

I am using ULTRA96 Evaliation Board with UltraScale+ MPSoC Processors. Can you please specify the major steps that will be required to do the following task.

1. Continuously monitor the temperature and Alarms through System Monitor.

2. Prepare a GUI where I can input the temperature and voltage limits and observe the continous data from SYSMON.

 

Hardware/Interface Cables:

Ultra96 Evaluation Board Rev. 1

USB to JTAB-UART 

 

Thanks

0 Kudos
Reply
1 Solution

Accepted Solutions
drjohnsmith
Teacher
Teacher
443 Views
Registered: ‎07-09-2009
In that case , its way outside what we can support you with,

a quick pointer,

https://www.xilinx.com/support/documentation/application_notes/xapp1172_zynq_ps_xadc.pdf
<== If this was helpful, please feel free to give Kudos, and close if it answers your question ==>

View solution in original post

4 Replies
drjohnsmith
Teacher
Teacher
488 Views
Registered: ‎07-09-2009
so what experiance level do you have ?
<== If this was helpful, please feel free to give Kudos, and close if it answers your question ==>
0 Kudos
Reply
481 Views
Registered: ‎02-01-2020
Begineer
0 Kudos
Reply
drjohnsmith
Teacher
Teacher
444 Views
Registered: ‎07-09-2009
In that case , its way outside what we can support you with,

a quick pointer,

https://www.xilinx.com/support/documentation/application_notes/xapp1172_zynq_ps_xadc.pdf
<== If this was helpful, please feel free to give Kudos, and close if it answers your question ==>

View solution in original post

415 Views
Registered: ‎02-01-2020
Thanks Mr. John, the article that you provided is a good place to start with.
0 Kudos
Reply