UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Visitor harsha_304
Visitor
965 Views
Registered: ‎02-22-2018

Unable to create a bootable boot.bin for a generated bit file in SD-Card mode ZCU102 in 2017.4 toolset Windows

Hi,

 

I am working on the Zynq Ultrascale+ MPSoc, ZCU102 Revision 1.1.

 

I have copied the pre-built images into the SD-Card and ran it on the board. The board boots fine with the pre-built images.

 

Now, I have written an FPGA code for which a bit file is also created.

 

I have used the http://www.wiki.xilinx.com/ZCU102+Image+creation+in+OSL+flow 

link to find the order for the files to be added for boot image creation in Xilinx SDK 2017.4(in Windows).

order I followed is:

fsbl

bit file

pmufw_image

bl31

u-boot.elf

 

Except for the bit file, I have used the other set of pre-built images from "2017.1-zcu102-release.tar.xz" section of http://www.wiki.xilinx.com/Zynq+2017.1+Release link.

 

After creating the boot image and copying it onto SD-Card, the board is not booting.

Below is what I am observing in the terminal:

øXilinx Zynq MP First Stage Boot Loader
Release 2017.4 Feb 22 2018 - 17:30:28
XPFW: Calling ROM PWRUP Handler..Done
XPFW: Calling ROM Isolation Handler..Done

 

On the board,I am able to observe INIT_B LED and PS_ERR_OUT LED glowing "RED".

 

Can I know where where I am wrong with Boot Image creation?

or If the procedure is wrong, can you point me in the proper direction?

0 Kudos
2 Replies
Scholar austin
Scholar
942 Views
Registered: ‎02-27-2008

Re: Unable to create a bootable boot.bin for a generated bit file in SD-Card mode ZCU102 in 2017.4 toolset Windows

All tools and images must use (be generated from 2017.4),

 

You cannot mix & match.


Tools must be consistent.

Austin Lesea
Principal Engineer
Xilinx San Jose
0 Kudos
Highlighted
Visitor harsha_304
Visitor
895 Views
Registered: ‎02-22-2018

Re: Unable to create a bootable boot.bin for a generated bit file in SD-Card mode ZCU102 in 2017.4 toolset Windows

Hi,

 

    Thank you for the response.

I have followed all the steps from 

https://www.xilinx.com/support/documentation/sw_manuals/xilinx2016_4/ug1209-embedded-design-tutorial.pdf

link.

 

The issue I had was with the security firmware file.

I started using the one from the above link and the board started to boot.