cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Observer
Observer
542 Views
Registered: ‎09-04-2019

Xilinx Zynq-7000 SoC ZC706 Evaluation SD card booting

Hi,  

1) i copied .bin file to SD Card and i loaded to Evaluation. how to verify SD card is booting . My device configuration is SW = 00110, 

i taken .bin file from https://www.xilinx.com/products/boards-and-kits/ek-z7-zc706-g.html#documentation

2) through JTAG configuration i tested BIST. all codes are programmed but i can't able see the output in terminal port.reference from xilinxreference from xilinxActual output i receivedActual output i received

 

Can any one please explain how to validate this design 

0 Kudos
Reply
5 Replies
Moderator
Moderator
503 Views
Registered: ‎11-09-2015

Hi @kapildev 

Are you using a proper serial COM terminal to check? You might want to try with tera term


Florent
Product Application Engineer - Xilinx Technical Support EMEA
**~ Don't forget to reply, give kudos, and accept as solution.~**
Observer
Observer
465 Views
Registered: ‎09-04-2019

Yeah i tried tera term serial monitor, Hyperterminal, and putty also . but i can't able to see the uart output.
0 Kudos
Reply
Moderator
Moderator
463 Views
Registered: ‎11-09-2015

Hi @kapildev 

When you connect the board to you computer, do you see a new COM port? If yes, you might want to try to re-install the drivers:

https://www.xilinx.com/support/answers/33569.html

If you cannot see the COM port, are you sure you are using the UART connector?


Florent
Product Application Engineer - Xilinx Technical Support EMEA
**~ Don't forget to reply, give kudos, and accept as solution.~**
0 Kudos
Reply
Observer
Observer
460 Views
Registered: ‎09-04-2019

Yes, I installed proper driver and i connected UART cable. In Serial monitor its showing port no and i connected that port

0 Kudos
Reply
Moderator
Moderator
457 Views
Registered: ‎11-09-2015

Hi @kapildev 

Then your board might be dammaged


Florent
Product Application Engineer - Xilinx Technical Support EMEA
**~ Don't forget to reply, give kudos, and accept as solution.~**
0 Kudos
Reply