cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Highlighted
Scholar
Scholar
1,012 Views
Registered: ‎02-01-2013

ZCU102 schematic clean-up

Jump to solution

This is confusing. If Xilinx plans on releasing schematics (for the 1.1 board, perhaps?), it might be a good time to clean this up:

2019-01-08_12-09-27.jpg

-Joe G.

 

1 Solution

Accepted Solutions
Highlighted
Moderator
Moderator
968 Views
Registered: ‎07-23-2015

@jg_bds Thank you for bringing this to our attention. Will have this captured internally so that if a new rev is designed, this typo will be cleaned up. 

- Giri
--------------------------------------------------------------------------------------------------------------------
There's no such thing as a stupid question. Feel free to ask but do a quick search to make sure it ain't already answered.
Keep conversing, give Kudos and Accept Solution when you get one.
-----------------------------------------------------------------------------------------------------------------------

View solution in original post

0 Kudos
3 Replies
Highlighted
Moderator
Moderator
969 Views
Registered: ‎07-23-2015

@jg_bds Thank you for bringing this to our attention. Will have this captured internally so that if a new rev is designed, this typo will be cleaned up. 

- Giri
--------------------------------------------------------------------------------------------------------------------
There's no such thing as a stupid question. Feel free to ask but do a quick search to make sure it ain't already answered.
Keep conversing, give Kudos and Accept Solution when you get one.
-----------------------------------------------------------------------------------------------------------------------

View solution in original post

0 Kudos
Highlighted
Scholar
Scholar
926 Views
Registered: ‎02-01-2013

Fret not, ZCU102 Community: the wiring on the PCB is correct.  This is just a schematic mix-up.

-Joe G.

 

Highlighted
Moderator
Moderator
874 Views
Registered: ‎07-23-2015

@jg_bds Yes,  I did verify yesterday based on your feedback and noticed the PCB layout is fine. Below is the net connection

zcu102_protect.JPG

Just the schematic has the typo. Missed putting this up yesterday and thanks for clarifying as well. 

- Giri
--------------------------------------------------------------------------------------------------------------------
There's no such thing as a stupid question. Feel free to ask but do a quick search to make sure it ain't already answered.
Keep conversing, give Kudos and Accept Solution when you get one.
-----------------------------------------------------------------------------------------------------------------------
0 Kudos