cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Highlighted
1,534 Views
Registered: ‎09-17-2018

ZCU111 DAC/ADC signal levels

Jump to solution

I just started getting familiar with the ZCU111 board and I'm trying to figure out some information about the DAC/ADC interfaces:

What is the max DAC output current? (in UG1287 the introduction is saying 20 or 32mA, but I didn't see it mentioned later on)

What is the ADC input voltage range?

Are the DAC/ADC 50 ohm terminated?

Any advice on where I can find this information is greatly appreciated.

 

Thanks for your support in advance!

Tags (4)
0 Kudos
1 Solution

Accepted Solutions
Highlighted
Xilinx Employee
Xilinx Employee
1,486 Views
Registered: ‎06-21-2018

Hi Tamas,

I believe you can find all that information in the DC and AC Datasheet:

https://www.xilinx.com/support/documentation/data_sheets/ds926-zynq-ultrascale-plus-rfsoc.pdf

Here is the link to the RFSoC Documentation page:

https://www.xilinx.com/products/silicon-devices/soc/rfsoc.html#documentation

Thanks,

Andres

 

 

View solution in original post

2 Replies
Highlighted
Xilinx Employee
Xilinx Employee
1,487 Views
Registered: ‎06-21-2018

Hi Tamas,

I believe you can find all that information in the DC and AC Datasheet:

https://www.xilinx.com/support/documentation/data_sheets/ds926-zynq-ultrascale-plus-rfsoc.pdf

Here is the link to the RFSoC Documentation page:

https://www.xilinx.com/products/silicon-devices/soc/rfsoc.html#documentation

Thanks,

Andres

 

 

View solution in original post

1,462 Views
Registered: ‎09-17-2018

Many thanks Andres!

0 Kudos