cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
749 Views
Registered: ‎12-06-2018

drill hole next to the fmc connector on the nexys video

Hi

I am designing a board to connect to the fmc connector on the nexys video board. for better stabilazation i want to use the drill holes next to the connector to screw the nexys video and my board together. But I need som distances, so I can make similar holes on my board.

Michelle

0 Kudos
Reply
2 Replies
Moderator
Moderator
708 Views
Registered: ‎10-19-2011

I belive the holes you are refering too are part of the FMC spec, you could find the dimensions there, or you may be able to contact digilent direcly. Looking over at the digilent page they do have a cad model, which might be exactly what you need (near the bottom of the page).

 

https://reference.digilentinc.com/reference/programmable-logic/nexys-video/start

-------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------
0 Kudos
Reply
Contributor
Contributor
630 Views
Registered: ‎04-27-2016

The distance between these two holes is 63 mm. Use a diameter of 2.7 mm. FMC module templates are available on github.com/FMCHUB

fmc_template.jpg

 

0 Kudos
Reply