cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
tchin123
Voyager
Voyager
399 Views
Registered: ‎05-14-2017

sfp connector cage nomenclature SFP (0,1,2,3) for Xilinx zcu102 development board

On the ZCU102, there is a 2x2 quad connector and cage assembly (R-OP-008080-6-F-N-26-F63) that accepts 4 SFP modules.

is there a drawing that display which of the quad module represent SFP0, SFP1, SFP2, SFP3 in respect to the 2x2 cage

Also on the ZCU106 there is a 1x2 dual connector assembly that accept 2 SFP module, Which one is SFP0 1nd SFP1 (right or left)

0 Kudos
6 Replies
tchin123
Voyager
Voyager
331 Views
Registered: ‎05-14-2017

does anyone has info on these dev bd (zcu102, 106)

0 Kudos
kdeshwal
Xilinx Employee
Xilinx Employee
250 Views
Registered: ‎11-12-2019

Hi @tchin123 ,

Check the schematics of zcu102 and zcu106 which is XTP-454 & XTP-469 respectively.
You will find the required details in these schematic.

Thanks,
Kuldeep

-------------------------------------------------------------------------------------------------------------
Please give Kudo and Accept as a Solution if solution provided seems helpful.
Have a look at our Versal Design Process Hub, Versal Blogs and the Versal Forum Useful Resources
-------------------------------------------------------------------------------------------------------------
tchin123
Voyager
Voyager
247 Views
Registered: ‎05-14-2017

unfortunately the schematic doesn't show the physical location for each SFP module

0 Kudos
anatoli
Moderator
Moderator
202 Views
Registered: ‎06-14-2010

Hello @tchin123 ,

Please download and check the Allegro and the Gerber files for each board and that should give/show you the info you are looking for:

https://www.xilinx.com/products/boards-and-kits/ek-u1-zcu102-g.html#documentation

image.png

https://www.xilinx.com/products/boards-and-kits/zcu106.html#documentation

image.png

Check the Gerber file and that has a .pdf version, where you'd get the info you are looking for:

e.g. ZCU106:

image.png

image.png

Hope this helps.

Kind Regards,
Anatoli Curran,
Xilinx Technical Support
------------------------------------------------------------------------------------------------

Don’t forget to reply, kudo, and accept as solution.

If starting with Versal, take a look at our Versal Design Process Hub and our
Versal Blogs

------------------------------------------------------------------------------------------------
anatoli
Moderator
Moderator
197 Views
Registered: ‎06-14-2010

And I would also normally expect to see the marking on the SFP cage itself, as in my example screenshot below, that was taken from the KCU105 board. Do you see the same on ZCU102/106 boards?

image.png

Hope this helps.

Kind Regards,
Anatoli Curran,
Xilinx Technical Support
------------------------------------------------------------------------------------------------

Don’t forget to reply, kudo, and accept as solution.

If starting with Versal, take a look at our Versal Design Process Hub and our
Versal Blogs

------------------------------------------------------------------------------------------------
0 Kudos
tchin123
Voyager
Voyager
181 Views
Registered: ‎05-14-2017

the zcu10, 2x2 cage doesn't come with any front plate nor any designation marking