UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Adventurer
Adventurer
320 Views
Registered: ‎06-22-2018

The initial port state of AXI SPI

Jump to solution

In PG153 it shows the  active low output ports have initial status of '1', but other outputs show '-'. So, what's the meaning of '-'. And what's the inital status of them?

0 Kudos
1 Solution

Accepted Solutions
Community Manager
Community Manager
234 Views
Registered: ‎07-23-2012

Re: The initial port state of AXI SPI

Jump to solution

From Table 2-2, you will see that the default value of Outputs are not defined for bi-directional ports (like IO0_O). These bidirectional ports have a tristate pin which determines the value driven on the output port.

As per the same table, the default value of these tri-state pins are 1 which means that the output ports will be in tri-state.

-----------------------------------------------------------------------------------------------
Please mark the post as "Accept as solution" if the information provided answers your query/resolves your issue.

Give Kudos to a post which you think is helpful.

View solution in original post

Capture.PNG
Capture1.PNG
2 Replies
Xilinx Employee
Xilinx Employee
248 Views
Registered: ‎01-21-2008

Re: The initial port state of AXI SPI

Jump to solution

Hi @diverger

Table 2-2 shows the  input anf output of the IP. Most of the OUTPUT signals are driven by the command and some are depends on the command acts as a bidirectional. Once you have generated the IP in Vivado design, please see the output signals in simulation for correct usacase for your configuration options. 

So Most of the signals are configuration driven outputs and that is the reason we have mentioned "-" in table 2-2.

 

0 Kudos
Community Manager
Community Manager
235 Views
Registered: ‎07-23-2012

Re: The initial port state of AXI SPI

Jump to solution

From Table 2-2, you will see that the default value of Outputs are not defined for bi-directional ports (like IO0_O). These bidirectional ports have a tristate pin which determines the value driven on the output port.

As per the same table, the default value of these tri-state pins are 1 which means that the output ports will be in tri-state.

-----------------------------------------------------------------------------------------------
Please mark the post as "Accept as solution" if the information provided answers your query/resolves your issue.

Give Kudos to a post which you think is helpful.

View solution in original post

Capture.PNG
Capture1.PNG