UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Explorer
Explorer
2,092 Views
Registered: ‎05-14-2015

programming eMMC flash

Jump to solution

A question about Zynq ultrascale+ XCZU7EV.

The below is a simplified block diagram of our system. I'm thinking how to program eMMC flash once I receive a board with a blank eMMC flash.

I want to store UBoot, Linux kernel image, FSBL and FPGA bit stream file into this eMMC flash. Then, next time, the system will boot from eMMC  flash.

Can JTAG be used for programming all these files into eMMC flash? Does Xilinx already has some tools for this purpose?

test.png

0 Kudos
1 Solution

Accepted Solutions
Moderator
Moderator
2,732 Views
Registered: ‎03-19-2014

Re: programming eMMC flash

Jump to solution

Yes, you can program eMMC on a Zynq UltraScale+ MPSoC    Refer to:

 

program flash help

-------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------

View solution in original post

3 Replies
Moderator
Moderator
2,733 Views
Registered: ‎03-19-2014

Re: programming eMMC flash

Jump to solution

Yes, you can program eMMC on a Zynq UltraScale+ MPSoC    Refer to:

 

program flash help

-------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------

View solution in original post

Adventurer
Adventurer
1,520 Views
Registered: ‎01-24-2018

Re: programming eMMC flash

Jump to solution

The reference you point to does not help.

It is in fact, one of many, many references on this site that do not help solve this issue.

 

Can y'all please provide a "down vote" button for answers like this?

 

0 Kudos
Moderator
Moderator
1,491 Views
Registered: ‎03-19-2014

Re: programming eMMC flash

Jump to solution

Replies to a thread that's listed as resolved tend to not get many responses.   I would advise you to create a new Forum post detailing your question / concern if you would like some assistance.

-------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------
0 Kudos