cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Highlighted
443 Views
Registered: ‎09-25-2019

DSP48E2 Subtraction output wrong

I have configured a DSP48E2 slice (through the IP catalog) to perform a CONCAT - PCIN operation. In an Aldec simulation, I am getting the pcout and p outputs to be different. pcout gives the desired output whereas p is set to 0. I was wondering if anyone had any issues like this in using the DPS48E2 through the IP Catalog.

 

 

Tags (2)
dsp48e2_notworking.PNG
0 Kudos
1 Reply
Highlighted
Moderator
Moderator
283 Views
Registered: ‎08-01-2007

Try not to customize the P output width, leave P output the default setting - full precision, see what happens. 

The P should be always identical to Pcout.

0 Kudos