Hardware Co-Simulation error when downloading bit file

[daldoul]

 I am using  System Generator to do Hardware co-cimulation for a sample example :  Addition and Multiplication,

---

---

When I Click the Start Simulation button I get an error  in the Log file :

--------------------------------- Version Log ----------------------------------
Version                                 Path
System Generator 14.2                   C:/Xilinx/14.2/ISE_DS/ISE/sysgen
Matlab 7.13.0.564 (R2011b)              C:/Program Files/MATLAB/R2011b
ISE                                     C:/Xilinx/14.2/ISE_DS/ISE
--------------------------------------------------------------------------------
Summary of Errors:
Error 0001: Error creating a session.
     Block: 'tutorial_2_co/tutorial hwcosim'
--------------------------------------------------------------------------------

Error 0001:

Reported by:
  'tutorial_2_co/tutorial hwcosim'

Details:
Error creating a session.
Error occurred during "Simulation Initialization".

--------------------------------------------------------------------------------

I can not find the cause of error because I think I have the right version as mention in this link :

http://http://www.xilinx.com/support/answers/17966.htm

[daldoul]

Also this is my configuration for the cable:

[bwiec]

Are you able to configure the device using this exact hardware setup using impact? Does autodetect work?

Also, are you launching sysgen properly from the start menu/shortcut?

[daldoul]

Thank you for your quick response,

I can configure the device using this exact hardware setup using impact as shown below,

---

but when i launch sysgen properly from the start menu/shortcut, I get this message on matlab : Unable to make work directory
and even so, I can find the xilinx blockset in the simulink library

[daldoul]

With iMPACT, I can programme the FPGA borad so I have no problem with the connexion to the borad, but I still get the error shown on my firts post with System Generator Co-Simulation.

[daldoul]

Maybe I didn't choose the right USB port , How can I know which port I have to select ?

---

[daldoul · Accepted solution]

I figured  out the problem : in the path of the  model, I have a space, so I delete this space and the Co-Simulation works fine 

[gaurav_acad]

please tell me how you figured out the path problem 

i aslo having the same problem as you shown in the figure 

[vijayenthiran]

I too have the same problem !!. Where you had space? Can you expalin with the snapshot ? Will be really useful to me.

[tejakr2002]

there is an option for automatically detecting the cable then i think u need to mention all these