cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Observer
Observer
1,088 Views
Registered: ‎04-17-2018

compatibility zynq 7020 and matlab (hdl coder and embedded)

Hi,

I try to connect my zynq 7020 (https://www.xilinx.com/products/boards-and-kits/1-571ww1.html)  to matlab and simulink but it doesn't connect (all peripherals are recognized in windows correctly).

I follow the video: https://it.mathworks.com/videos/a-guided-workflow-for-zynq-using-matlab-and-simulink-86427.html?form_seq=0u0VxnSA

but when i write the command zynq on workspace of matlab, i have the netx error:

>> zynq
Error using codertarget.zynq.internal.LinuxShell/setupZynqHardware (line 500)
Could not connect to the hardware over Serial Port.
Check that USB cable is plugged into 'USB-to-UART' port of the hardware and the power switch is turned on.
If this error persists, switch off the hardware, wait for 10 seconds, switch on the hardware and then
repeat this step.

 

However, i have opened the configuration of embedded package of matlab and i see only the board zynq zc702, zynq zc706 and zedboard (figure in attachments). Hence, is the zynq z7020 not compatible?

Immagine.jpg
0 Kudos
3 Replies
Highlighted
Scholar
Scholar
1,056 Views
Registered: ‎03-28-2016

The Zynq 7020 is the name of an FPGA device not the name of an eval board.  The ZC702 and the ZedBoard are both eval boards that use the Zynq 7020.

 

Only certain eval boards are supported by the MathWorks software that you are trying to use.  If your board is not one of the ones listed in the menu below, then it is not compatible with the Mathworks software.

 

Ted Booth | Tech. Lead FPGA Design Engineer | DesignLinx Solutions
https://www.designlinxhs.com
0 Kudos
Highlighted
Observer
Observer
1,052 Views
Registered: ‎04-17-2018

so this https://www.xilinx.com/products/boards-and-kits/1-571ww1.html is not compatible? because i read part number MYS-7Z020-C-S (series 7z020?)
0 Kudos
Highlighted
Newbie
Newbie
558 Views
Registered: ‎03-18-2019

Can you kindly share the menu?
0 Kudos