UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
159 Views
Registered: ‎07-13-2018

Spartan 6 slave serial configuration issue

Jump to solution

Hi,

We have SPARTAN-6 FPGA usually we will be configuring FPGA through JTAG, but now we are planning to configure FPGA with the processor, we are generating.Bin file from Xilinx ise software but referring to document Xapp502 a Perl script is required for generating.Bin file. Is really Perl script is needed to generate .Bin file for slave serial mode?

1 Solution

Accepted Solutions
105 Views
Registered: ‎01-22-2015

Re: Spartan 7 slave serial configuration issue

Jump to solution

@sivakumarreddy50 

   sorry it's spartan 6 using slave serial mode
No worries.  Slave Serial for Spartan-6 is described by Fig 2-3 in UG380.  Perl script will not be needed to reformat .bin file for Spartan-6 when using Slave Serial.

Mark

4 Replies
Xilinx Employee
Xilinx Employee
147 Views
Registered: ‎08-10-2008

回复: Spartan 7 slave serial configuration issue

Jump to solution

Are you asking for the perl?

https://secure.xilinx.com/webreg/clickthrough.do?cid=139211 

xapp502 gives the link to download all the ref fils.

------------------------------------------------------------------------------------------------------------
Don't forget to reply, kudo, and accept as solution.
---------------------------------------------------------------------------------------------------------
0 Kudos
140 Views
Registered: ‎01-22-2015

Re: Spartan 7 slave serial configuration issue

Jump to solution

@sivakumarreddy50 

Welcome to the Xilinx Forum!

Since you are planning to use the microprocessor in Slave-Serial mode (see Fig 2.2 in Xilinx document UG470) then PERL script is not needed to reformat the .bin file.

If you use Slave-SelectMAP mode then the PERL script is needed.

Mark

124 Views
Registered: ‎07-13-2018

Re: Spartan 7 slave serial configuration issue

Jump to solution
sorry it's spartan 6 using slave serial mode
0 Kudos
106 Views
Registered: ‎01-22-2015

Re: Spartan 7 slave serial configuration issue

Jump to solution

@sivakumarreddy50 

   sorry it's spartan 6 using slave serial mode
No worries.  Slave Serial for Spartan-6 is described by Fig 2-3 in UG380.  Perl script will not be needed to reformat .bin file for Spartan-6 when using Slave Serial.

Mark