UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Visitor eholtzclaw
Visitor
80 Views
Registered: ‎08-03-2017

list_property command

Jump to solution

From XAPP1233, page 17

"list_property_value BITSTREAM.CONFIG.CONFIGRATE [current_design]"

What needs to be entered for [current_design]?

Thanks,

>>Eric

0 Kudos
1 Solution

Accepted Solutions
Xilinx Employee
Xilinx Employee
54 Views
Registered: ‎02-14-2014

Re: list_property command

Jump to solution

Hi @eholtzclaw ,

Application note mentions that you need to run this command with an open synthesized or implemented design for the target FPGA. So current_design here refers to either open synthesized or implemented design. [current_design] will be anyway replaced by tool with synthesized or implemented design name (whichever is open).

Regards,
Ashish
----------------------------------------------------------------------------------------------
Kindly note- Please mark the Answer as "Accept as solution" if information provided is helpful.
Give Kudos to a post which you think is helpful and reply oriented.
----------------------------------------------------------------------------------------------
2 Replies
Scholar dpaul24
Scholar
62 Views
Registered: ‎08-07-2014

Re: list_property command

Jump to solution

@eholtzclaw,

You can leave it to current_design

set_property BITSTREAM.CONFIG.CONFIGRATE 66 [current_design]

This is what we are doing when using set_property CONFIG_MODE SPIx2 [current_design]

--------------------------------------------------------------------------------------------------------
FPGA enthusiast!
All PMs will be ignored
--------------------------------------------------------------------------------------------------------
0 Kudos
Xilinx Employee
Xilinx Employee
55 Views
Registered: ‎02-14-2014

Re: list_property command

Jump to solution

Hi @eholtzclaw ,

Application note mentions that you need to run this command with an open synthesized or implemented design for the target FPGA. So current_design here refers to either open synthesized or implemented design. [current_design] will be anyway replaced by tool with synthesized or implemented design name (whichever is open).

Regards,
Ashish
----------------------------------------------------------------------------------------------
Kindly note- Please mark the Answer as "Accept as solution" if information provided is helpful.
Give Kudos to a post which you think is helpful and reply oriented.
----------------------------------------------------------------------------------------------