cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
9,742 Views
Registered: ‎04-06-2010

What are the command lines of the floorplan of the PlanAhead?

What are the command lines of the floorplan of the PlanAhead? Can I use them for re-editing the UCF file?

 

Thanks a lot!

0 Kudos
1 Reply
Highlighted
Xilinx Employee
Xilinx Employee
9,713 Views
Registered: ‎08-10-2007

You can export the constraints into a UCF file which you can then use for the design.  Just go to File -> Export Constraints and follow the directions.

 

Or if you're wondering what commands are taking place when moving things around graphically on the floorplan have a look at the Console tab at the bottom.  This will show you the commands being used.  These are mostly Tcl commands and you can't use them to affect a generic UCF file, but you can take note of them and use them in another PlanAhead project.

0 Kudos