UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Adventurer
Adventurer
884 Views
Registered: ‎10-11-2017

AXI Quad SPI:no sck signal output

Jump to solution

Hello everyone,I use AXI Quad SPI v3.2 in Block Design with the Kintex7-2 device.The configuration of the SPI is:

 1.png

I have noted this :

2.png

So the core is configured with Frequency Ratio set to 2 and the AXI is configured to operate at 100 MHz). the ext_spi_clk is 80MHz.But I found no  sck signal  output.

I am using VIVADO 2017.2 on Windows7.

0 Kudos
1 Solution

Accepted Solutions
Highlighted
Adventurer
Adventurer
1,226 Views
Registered: ‎10-11-2017

回复: AXI Quad SPI:no sck signal output

Jump to solution
I have solved it.

I found that when configure Microblaze without check 'Use Instruction and Data Caches',it will work normally.

But I don't konw why.
0 Kudos
1 Reply
Highlighted
Adventurer
Adventurer
1,227 Views
Registered: ‎10-11-2017

回复: AXI Quad SPI:no sck signal output

Jump to solution
I have solved it.

I found that when configure Microblaze without check 'Use Instruction and Data Caches',it will work normally.

But I don't konw why.
0 Kudos