cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Highlighted
Visitor
Visitor
3,577 Views
Registered: ‎06-14-2012

Custom IP interrupts sensitivity

With Vivado 15.2 I'm packaging some custom IP that has an interrupt output that will go to the AXI interrupt controller and a microblaze processor. I want the interrupt to be edge sensitive. So when I package the IP I go to "Ports and Interfaces" and edit the interface that has my interrupt and give it a parameter "SENSITIVITY" with a value of "EDGE_RISING". But when I put that IP on my main project's block design and double click on the interrupt pin it says "LEVEL_RISING". And as a result the interrupt controller then makes the wrong decision about the interrupt sensitivity and things don't work. How do I package my IP to get the correct interrupt sensitivity?

0 Kudos
2 Replies
Highlighted
Community Manager
Community Manager
3,535 Views
Registered: ‎07-23-2012

Can you overwrite the sensitivity parameter via TCL?
-----------------------------------------------------------------------------------------------
Please mark the post as "Accept as solution" if the information provided answers your query/resolves your issue.

Give Kudos to a post which you think is helpful.
0 Kudos
Highlighted
Moderator
Moderator
3,314 Views
Registered: ‎07-31-2012

Hi,

 

Refer to https://www.xilinx.com/support/answers/60837.html

 

Regards

Praveen


-------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------
0 Kudos