cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
faheem
Visitor
Visitor
2,130 Views
Registered: ‎03-04-2010

How to add my ip in chipscope?

I have connected an fft core to the mpmc using npi connection.I wish to monitor it on chipscope. The problem is that when i add chipscope to my project(from Debug menu), I can see the name of IP but no signals are shown.Similarly,my ip is connected to PIM2 port of mpmc but if I check the RAM sigs,all ports are shown except PIM2.
0 Kudos
1 Reply
archu54in
Contributor
Contributor
2,088 Views
Registered: ‎08-04-2009

If your IPcore is seen in Debug menu and if no ports are there , then it means that your IP core does not have any external ports ..  Check whether your IP core has external ports ... Using chipscope you can monitor only the external ports of each IP instance...

 

Regards
Archu
0 Kudos