cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
edadangtri
Contributor
Contributor
786 Views
Registered: ‎12-03-2018

bootgen for Microblaze

Jump to solution

Hi,

I am trying to create a .bin file from a .bit file and a .elf file for a Microblaze that is running in a Kintex KU065 part.  As far as I know, SDK only supports this operation for Zynq parts.  However, I have found that there is a bootgen utility in the SDK/bin folder of my Xilinx installation.  I created a .bif file that points to the .bit and .elf files, but when I run bootgen, I get the following error:

[ERROR] : Sequential addresses are going backwards!

 

What am I doing wrong?

Also, I'm using Vivado/SDK 2017.4

 

Thanks,
Dan

0 Kudos
Reply
1 Solution

Accepted Solutions
glena
Moderator
Moderator
714 Views
Registered: ‎03-19-2014

Updatemem is discussed in UG898.   Bootgen in UG1283.  

-------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------

View solution in original post

0 Kudos
Reply
3 Replies
glena
Moderator
Moderator
724 Views
Registered: ‎03-19-2014

The MicroBlaze flow is to use updatemem to merge the .elf iand .bit into a .bit.   You can then convert that merged bitstream into a .bin

-------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------
0 Kudos
Reply
edadangtri
Contributor
Contributor
722 Views
Registered: ‎12-03-2018

Do you have any documentation to guide me in this process?

0 Kudos
Reply
glena
Moderator
Moderator
715 Views
Registered: ‎03-19-2014

Updatemem is discussed in UG898.   Bootgen in UG1283.  

-------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------

View solution in original post

0 Kudos
Reply