cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Adventurer
Adventurer
301 Views
Registered: ‎11-26-2018

FSBL XFSBL_ERROR_BITSTREAM_LOAD_FAIL

Jump to solution

Hi,

I'm trying to start petalinux but I have a problem in the FSBL. I get this error:

Xilinx Zynq MP First Stage Boot Loader 
Release 2019.1   Oct  8 2020  -  13:36:10
Reset Mode      :       System Reset
Platform: Silicon (4.0), Cluster ID 0x80000000
Running on A53-0 (64-bit) Processor, Device Name: XCZU7EV
Initializing DDR ECC
Address 0x0, Length 80000000, ECC initialized 
Address 0x800000000, Length 80000000, ECC initialized 
Processor Initialization Done 
================= In Stage 2 ============ 
SD1 Boot Mode 
SD: rc= 0
File name is 1:/BOOT.BIN
Multiboot Reg : 0x0 
Image Header Table Offset 0x8C0 
*****Image Header Table Details******** 
Boot Gen Ver: 0x1020000 
No of Partitions: 0x5 
Partition Header Address: 0x440 
Partition Present Device: 0x0 
Initialization Success 
======= In Stage 3, Partition No:1 ======= 
UnEncrypted data Length: 0x49AA7D 
Data word offset: 0x49AA7D 
Total Data word length: 0x49AA7D 
Destination Load Address: 0xFFFFFFFF 
Execution Address: 0x0 
Data word offset: 0xF9B0 
Partition Attributes: 0x26 
Destination Device is PL, changing LoadAddress
Non authenticated Bitstream download to start now
DMA transfer done 
XFSBL_ERROR_BITSTREAM_LOAD_FAIL
Partition 1 Load Failed, 0x37
================= In Stage Err ============ 
Fsbl Error Status: 0x0

 The problem appear when I put a ip block in the design. If i create a project with only the zynq block it works fine. I think there is a wrong configuration but I don't know where.

Andrea

0 Kudos
Reply
1 Solution

Accepted Solutions
Adventurer
Adventurer
229 Views
Registered: ‎11-26-2018

Solved, it was a wrong ddr configuration in the zynq block.

View solution in original post

0 Kudos
Reply
1 Reply
Adventurer
Adventurer
230 Views
Registered: ‎11-26-2018

Solved, it was a wrong ddr configuration in the zynq block.

View solution in original post

0 Kudos
Reply