UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Observer jqsam1
Observer
1,455 Views
Registered: ‎02-16-2015

Petalinux 2015.4 - Adding Flash Parts into sf_params.c

Good Day Everyone,

 

I am currently facing an issue where U-Boot isnt able to detect (through sf_probe) my QSPI flash (Micron - N25Q00). After finding solutions on the web, i realised new Flash Parts can be added into sf_params.c to allow the U-boot to recognise the Flash part. The question is regarding how do i know that the U-BOOT that is rebuild is using the newly saved sf_params.c and not using the previous sf_params.c instead? Up till now i was not able to figure out whether the new sf_params.c isnt taking effect or i have entered the wrong parameters for the flash part inside sf_params.c. I am developing the project using Vivado 2015.4 on a KINTEX7 custom board using a microblaze processor and axi_quad_spi ip core.

Error reported during sf_probe:
SF : Unsupported Flash IDs: manuf 10, jedec dd10, ext_jedec 0800
Failed to initialize SPI flash at 0:0 (error -22)

Is there anyway to decode what the error -22 is refering to?
Any help would be nice.. thanks in advance! 

Regards,
Sam 

0 Kudos