cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Observer
Observer
691 Views
Registered: ‎05-04-2018

Unable to download dt_overaly.tcl

Jump to solution
0 Kudos
1 Solution

Accepted Solutions
Highlighted
Moderator
Moderator
513 Views
Registered: ‎09-12-2007

Re: Unable to download dt_overaly.tcl

Jump to solution

The file is seen below:

set hdf <path to your hdf file>.hdf

set hw [hsi::open_hw_design $hdf]
hsi::set_repo_path ./repo
hsi::create_sw_design sw1 -proc psu_cortexa53_0 -os device_tree
hsi::set_property CONFIG.dt_overlay true [hsi::get_os]
hsi::generate_bsp -dir dtg_out
hsi::close_hw_design $hw

 

You can add this to a TCL, and source from XSCT.

 

I also have attached a helper_proc.tcl that you can use to create the pl.dtbo, and the bit.bin file needed when using overlays.

Source this in XSCT, and use the procs below to create the proc below:

  • generate_dts <path to hdf>.hdf
    bit2bin <path to bit>.bit

View solution in original post

3 Replies
Highlighted
Moderator
Moderator
623 Views
Registered: ‎11-09-2015

Re: Unable to download dt_overaly.tcl

Jump to solution

Hi @axmei,

I tested it and it is working for me. Can you try again? Maybe right click on the link and click save link as.

Regards,


Florent
Product Application Engineer - Xilinx Technical Support EMEA
**~ Don't forget to reply, give kudos, and accept as solution.~**
0 Kudos
Highlighted
524 Views
Registered: ‎09-10-2018

Re: Unable to download dt_overaly.tcl

Jump to solution

The link does not work for me either..  Might it be some premissions about being inside xilinx and outside ?  (is it published to the world)

 

 

0 Kudos
Highlighted
Moderator
Moderator
514 Views
Registered: ‎09-12-2007

Re: Unable to download dt_overaly.tcl

Jump to solution

The file is seen below:

set hdf <path to your hdf file>.hdf

set hw [hsi::open_hw_design $hdf]
hsi::set_repo_path ./repo
hsi::create_sw_design sw1 -proc psu_cortexa53_0 -os device_tree
hsi::set_property CONFIG.dt_overlay true [hsi::get_os]
hsi::generate_bsp -dir dtg_out
hsi::close_hw_design $hw

 

You can add this to a TCL, and source from XSCT.

 

I also have attached a helper_proc.tcl that you can use to create the pl.dtbo, and the bit.bin file needed when using overlays.

Source this in XSCT, and use the procs below to create the proc below:

  • generate_dts <path to hdf>.hdf
    bit2bin <path to bit>.bit

View solution in original post