UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Visitor varun_shah
Visitor
4,427 Views
Registered: ‎03-25-2014

varun_shah Posts: 12 Registered: ‎03-25-2014 0 linux karnal uImage problam cant synchronize with .dtb file

 

I am using zynq ZC703 and i make a u-boot.elf ,Uimage and system.dts file.

 

1> i made a u-boot.elf file by following command
make zynq_zc70x_config
make all
cp u-boot u-boot.elf

 

2> i made a vivardo project and made export hardwear in SDK
in SDK Xilinx Toos-> Repositories i add device-tree-xlnx- (downloaded from git hub)
after that File->New->Board Support package i make devicetree system.dts file
i made system.dtb file by
dtc -I dts -O dtb -o system.dtb system.dts

 

3>i downloaded linux-xlnx from git hub and make uImage by
make ARCH=arm UIMAGE_LOADADDR=0x8000 uImage

bui i thing system.dts and uImage are not synchronize so i change uImage ,turned off the fixed device tree address in the kernel configuration by make ARCH=arm menuconfig

System Type->Xilinx Specific Features -> Device Tree At Fixed Address

 

But  terminal output is in attachment pls check that one

0 Kudos
1 Reply
Highlighted
Xilinx Employee
Xilinx Employee
4,413 Views
Registered: ‎03-13-2012

Re: varun_shah Posts: 12 Registered: ‎03-25-2014 0 linux karnal uImage problam cant synchronize with .dtb file

You seem to use an ancient version of Linux. I think it is too old to have any version of DTG working with it.

In general, you should update and you should probably take a look at Petalinux.

0 Kudos