cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Chetan140
Visitor
Visitor
230 Views
Registered: ‎05-20-2020

100G PL Ethernet in Zynq RFSoC

Jump to solution

Hi,

We have a 100G PL Ethernet connected to the gen 3 Zynq RFSoC custom board. We need to test the ethernet using Linux. For that, I'm going through the PG165 guide. We are using GTY transceivers in CAUI-4 mode on our board. As per the guide do we need to send a mail to Ethernet_mgmt@xilinx.com for access? If yes then is it free?

Since I'm completely new to this, are there any documents for using/testing the 100G PL ethernet? Please help us

Regards,

Chetan

Tags (2)
0 Kudos
1 Solution

Accepted Solutions
nanz
Moderator
Moderator
207 Views
Registered: ‎08-25-2009

Hi @Chetan140 ,

For MPSoC/RFSoC, you should look at the CMAC IP as per PG203:

https://www.xilinx.com/support/documentation/ip_documentation/cmac_usplus/v3_1/pg203-cmac-usplus.pdf

You will not need a special request. The core is coming with Vivado tool unless you need AN/LT functionalities. Please check the above doc for more details. 

Please note that Xilinx does not have a driver for 100G yet. 

For validation, please refer to the PG above and example design. 


-------------------------------------------------------------------------------------------

Don’t forget to reply, kudo, and accept as solution.

If starting with Versal take a look at our Versal Design Process Hub and our Versal Blogs and our Versal Ethernet Sticky Note.

-------------------------------------------------------------------------------------------

View solution in original post

0 Kudos
1 Reply
nanz
Moderator
Moderator
208 Views
Registered: ‎08-25-2009

Hi @Chetan140 ,

For MPSoC/RFSoC, you should look at the CMAC IP as per PG203:

https://www.xilinx.com/support/documentation/ip_documentation/cmac_usplus/v3_1/pg203-cmac-usplus.pdf

You will not need a special request. The core is coming with Vivado tool unless you need AN/LT functionalities. Please check the above doc for more details. 

Please note that Xilinx does not have a driver for 100G yet. 

For validation, please refer to the PG above and example design. 


-------------------------------------------------------------------------------------------

Don’t forget to reply, kudo, and accept as solution.

If starting with Versal take a look at our Versal Design Process Hub and our Versal Blogs and our Versal Ethernet Sticky Note.

-------------------------------------------------------------------------------------------

View solution in original post

0 Kudos