cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Highlighted
Explorer
Explorer
3,389 Views
Registered: ‎04-28-2010

ethernet point to point cosimulation error on xupv5 lx110t board

Sir,

       I have attached a small tutorial for ethernet poini to point cosimulation for Spartan 6 lx150t development kit. I have tried the same for xupv5lx110t evaluation kit on a windows 7 machine using ise 13.2 with matlab R2010a, using ethernet crossover cable(which I have tested working fine for internet connection). But getting the following error. Please suggest me..

 

===================================================error=================================================================

Error in Point-to-point Ethernet Hardware Co-simulation.

Timeout before receiving any data through Ethernet.

The Ethernet core on the target FPGA device may have timed out after its 7-hour functional period for evaluation. For more information about getting the full version of the core, please visit the product page at 
"http://www.xilinx.com/systemio/temac/index.htm"

Please reset the FPGA board before restarting the simulation.

A problem may exist in the connection between the host and the FPGA board. Please check the Ethernet cable, network interface card status, and network settings to ensure that the Ethernet connection is functioning properly.
Error occurred during "Simulation Initialization".


Reported by:
'conv5x5_video_testbench/FPGA Processing/conv5x5_video_ex hwcosim'

 =================================================================================================================================

Best Regards
Chandrajit
Tags (1)
0 Kudos
2 Replies
Highlighted
Xilinx Employee
Xilinx Employee
3,349 Views
Registered: ‎04-16-2008

Since this issue relates to hardware cosim you might want to try posting under the DSP Tools forum.

-------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------
0 Kudos
Highlighted
Xilinx Employee
Xilinx Employee
3,344 Views
Registered: ‎11-28-2007

Note that there is no Ethernet Point to point cosimulation plugin installed for xupv5lx110t board by default. Where did you get the plugin for your simulation?


@chandrajit_pal wrote:

Sir,

       I have attached a small tutorial for ethernet poini to point cosimulation for Spartan 6 lx150t development kit. I have tried the same for xupv5lx110t evaluation kit on a windows 7 machine using ise 13.2 with matlab R2010a, using ethernet crossover cable(which I have tested working fine for internet connection). But getting the following error. Please suggest me..

 

===================================================error=================================================================

Error in Point-to-point Ethernet Hardware Co-simulation.

Timeout before receiving any data through Ethernet.

The Ethernet core on the target FPGA device may have timed out after its 7-hour functional period for evaluation. For more information about getting the full version of the core, please visit the product page at 
"http://www.xilinx.com/systemio/temac/index.htm"

Please reset the FPGA board before restarting the simulation.

A problem may exist in the connection between the host and the FPGA board. Please check the Ethernet cable, network interface card status, and network settings to ensure that the Ethernet connection is functioning properly.
Error occurred during "Simulation Initialization".


Reported by:
'conv5x5_video_testbench/FPGA Processing/conv5x5_video_ex hwcosim'

 =================================================================================================================================




 

 

 

Cheers,
Jim
0 Kudos