cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
marezaei
Visitor
Visitor
944 Views
Registered: ‎12-24-2018

Artix-7: Failure to set flash parameters

Hi, 

We have been working with Trenz Electronics' module "TE0710-02-100-2CF" for a while and we have been able to program the FPGA over the JTAG with no problem. We have alse been able to program the QSPI flash once and after that, whenever we try to reconfigure the flash, we get the following message:

 [Labtools 27-3347] Flash Programming Unsuccessful: Failure to set flash parameters.

has anybody else faced this problem with flash programming? We are using Vivado 2018.3. 

Thank you

0 Kudos
Reply
1 Reply
kkn
Moderator
Moderator
915 Views
Registered: ‎01-15-2008

@marezaei 

 

what is the design you have loaded to the flash? does that alter any flash registers after the fpga is configured?

Flash might have entered into write protect mode. Are you able to configure the fpga with the current contents of the flash?

Do you have another board to try with a simple design to see if that is able to program the flash?