cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
marzhan_123
Contributor
Contributor
1,943 Views
Registered: ‎01-04-2017

Create configuration file

Jump to solution

HeLLo!!! Please help me to find out the solution of this problem. Appropriate configuration memory part for the  Zedboad is MT41J128M16HA-15E:D or MT41K128M16JT-125, but I've chosen mt25ql512 as I assume these group matched ones. When I wanted create configuration file 

write_cfgmem -format MCS -size 512 -interface bpix16 -loadbit "up 0x0 /
C:/Users/Administrator/Desktop/vivado/REPORT.runs/impl_1/design_1_wrapper.bit" /

I got following errors:

ERROR: [Bitstream 40-46] File / cannot be opened for input.
ERROR: [Writecfgmem 68-7] Could not load bitfile /.
ERROR: [Common 17-39] 'write_cfgmem' failed due to earlier errors.

I have tried to increase and decrease the memory size and change the memory parts but still there is same error.

Thanks in advance.

0 Kudos
1 Solution

Accepted Solutions
ashok.cheepati
Contributor
Contributor
2,848 Views
Registered: ‎01-18-2013

Hi,

 

Zedboad is MT41J128M16HA-15E:D or MT41K128M16JT-125, these are DR3 memories whch you mentioned in the post. if yu want to configure Zynq you should select QSPI flash. If you wnat to select correct QSPI please check the below link.

 https://www.xilinx.com/support/answers/50991.html

 

Best Regards,

-----------------

Please accept as a solution if it solves your problem.

--Ashok

View solution in original post

0 Kudos
1 Reply
ashok.cheepati
Contributor
Contributor
2,849 Views
Registered: ‎01-18-2013

Hi,

 

Zedboad is MT41J128M16HA-15E:D or MT41K128M16JT-125, these are DR3 memories whch you mentioned in the post. if yu want to configure Zynq you should select QSPI flash. If you wnat to select correct QSPI please check the below link.

 https://www.xilinx.com/support/answers/50991.html

 

Best Regards,

-----------------

Please accept as a solution if it solves your problem.

--Ashok

View solution in original post

0 Kudos