cancel
Showing results for 
Search instead for 
Did you mean: 
Voyager
Voyager
415 Views
Registered: ‎05-14-2017

startup primitive default setting connection

Jump to solution

The Ultrascale Kintex PCIe core has a block of signal from the STARTUP Primitive that are input which I need to tie high or low. They show up from the pcie3_ultrascale_0.vho

These signals appear on the pcie_ultrascale component when the Tandem feature is selected from the wizard.

PG156 doesn't describe how to connect them in my instantiation instance. The list of input signal are shown below. What document describe the condition or state required to connect them properly if I don't need them.

--    startup_do => startup_do,
--    startup_dts => startup_dts,
--    startup_fcsbo => startup_fcsbo,
--    startup_fcsbts => startup_fcsbts,
--    startup_gsr => startup_gsr,
--    startup_gts => startup_gts,
--    startup_keyclearb => startup_keyclearb,
--    startup_pack => startup_pack,
--    startup_usrcclko => startup_usrcclko,
--    startup_usrcclkts => startup_usrcclkts,
--    startup_usrdoneo => startup_usrdoneo,
--    startup_usrdonets => startup_usrdonets,

0 Kudos
1 Solution

Accepted Solutions
Highlighted
Xilinx Employee
Xilinx Employee
387 Views
Registered: ‎08-25-2010

回复: startup primitive default setting connection

Jump to solution

Hi @tchin123

 

Please refer to table 7-11,Pin Descriptions in ug570:

http://www.xilinx.com/support/documentation/user_guides/ug570-ultrascale-configuration.pdf

 

Thanks
Simon
-------------------------------------------------------------------------
Don't forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------

View solution in original post

0 Kudos
1 Reply
Highlighted
Xilinx Employee
Xilinx Employee
388 Views
Registered: ‎08-25-2010

回复: startup primitive default setting connection

Jump to solution

Hi @tchin123

 

Please refer to table 7-11,Pin Descriptions in ug570:

http://www.xilinx.com/support/documentation/user_guides/ug570-ultrascale-configuration.pdf

 

Thanks
Simon
-------------------------------------------------------------------------
Don't forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------

View solution in original post

0 Kudos