cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Highlighted
Contributor
Contributor
4,545 Views
Registered: ‎11-02-2009

MIG - Not evaluation board supported - what to do?

Hi,

I have the Virtex 5 evaluation board. Seems that the MIG does not support this board. 

 

What to do? 

Is it possible to change the UCF file manually to change the LOC pins in order to connect to the real DDR2 pins following the schematics?

 

Thanks

Omar

 

0 Kudos
3 Replies
Highlighted
Xilinx Employee
Xilinx Employee
4,526 Views
Registered: ‎12-17-2007

Yes, MIG let's you specify a custom placement for the pins.  One of the last panels in the MIG customization GUI asks whether you want MIG to automatically pick the placement or if you want to do it manually.

 

-Tony 

-------------------------------------------
this space intentionally left blank
0 Kudos
Highlighted
Xilinx Employee
Xilinx Employee
4,516 Views
Registered: ‎10-23-2007

One additional note on this direct pin selection feature in MIG: it will only work if the original board layout meets the requirements of the MIG design.  Otherwise it will not pass the rule check and not allow you to create the design.

 

Which board specifically is this?  Does it have a part number or board number?

 

0 Kudos
Highlighted
Contributor
Contributor
4,495 Views
Registered: ‎11-02-2009

The board number is: 00183E007325.

Is the evaluation board from the Xilinx university program. Rev A

 

 

0 Kudos