UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

Reply

Aurora_Single Mode SFP selection in KINTEX KC705

Highlighted
Explorer
Posts: 325
Registered: ‎03-29-2017

Aurora_Single Mode SFP selection in KINTEX KC705

I am using a SFP [EOLS-PX-GU-20] which has different data rates:2.48832Gbps upstream and 9.95328Gbps downstream. Is their any possibility to use that SFP in KINTEX KC705.

Posts: 2,770
Kudos: 353
Solutions: 252
Registered: ‎02-16-2010

Re: Aurora_Single Mode SFP selection in KINTEX KC705

What is your design target line rates? With Aurora, you will need to have Tx and Rx to be at same line rate.
------------------------------------------------------------------------------
Don't forget to reply, give kudo and accept as solution
------------------------------------------------------------------------------
Explorer
Posts: 325
Registered: ‎03-29-2017

Re: Aurora_Single Mode SFP selection in KINTEX KC705

In Kintex KC705, I need to use different data rates:2.48832Gbps upstream and 9.95328Gbps downstream in Aurora Protocol. Is it possible or not ?

 

 

Posts: 2,770
Kudos: 353
Solutions: 252
Registered: ‎02-16-2010

Re: Aurora_Single Mode SFP selection in KINTEX KC705

Aurora IP does not have the option to have Tx and Rx at different data rates. You use case will require adjusting the clocking and GT parameters for either upstream or downstream.
------------------------------------------------------------------------------
Don't forget to reply, give kudo and accept as solution
------------------------------------------------------------------------------