UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Observer annand
Observer
3,846 Views
Registered: ‎01-09-2012

Virtex6 Embedded e-mac in trispeed mode

Jump to solution

When the embedded e-mac configured in tri-speed mode, will it automatically detect the speed and give the indication through the output pin "EMACSPEEDIS10100"? Or does it require an MDIO interface to communicate with the PHY?

 

Thanks

 

 

Tags (3)
0 Kudos
1 Solution

Accepted Solutions
Xilinx Employee
Xilinx Employee
4,490 Views
Registered: ‎04-16-2008

Re: Virtex6 Embedded e-mac in trispeed mode

Jump to solution

The user will need to program the TEMAC to the correct speed. 

 

See http://www.xilinx.com/support/documentation/ip_documentation/v6_emac_gsg545.pdf
Debugging Designs -> Hardware Debug ->Configuring theEtherent MAC to the Correct Speed for more information

-------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------
3 Replies
Xilinx Employee
Xilinx Employee
4,491 Views
Registered: ‎04-16-2008

Re: Virtex6 Embedded e-mac in trispeed mode

Jump to solution

The user will need to program the TEMAC to the correct speed. 

 

See http://www.xilinx.com/support/documentation/ip_documentation/v6_emac_gsg545.pdf
Debugging Designs -> Hardware Debug ->Configuring theEtherent MAC to the Correct Speed for more information

-------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------
Observer annand
Observer
3,780 Views
Registered: ‎01-09-2012

Re: Virtex6 Embedded e-mac in trispeed mode

Jump to solution

Thanks for the information...

 

Regards

 

Anand

 

0 Kudos
Visitor elotb
Visitor
1,798 Views
Registered: ‎02-14-2015

Re: Virtex6 Embedded e-mac in trispeed mode

Jump to solution

excuse me, if user has to read PHY register via MDIO to determine whether EMAC works at 10/100 or 1000 Mbps. then what is this signal "EMACSPEEDIS10100" (output from EMAC core)for?useless?

thank you

0 Kudos