cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Highlighted
Adventurer
Adventurer
3,323 Views
Registered: ‎03-06-2015

4 UARTs interfacing with Zynq processor

Jump to solution

Hi all,

 

We need to implement 4 UARTs with zynq ps in one of our project. For zynq processor only 2 UARTs support is there. Is there any procedure to 2 UARTS interfacing to PL but the output will be from PS side

 

please suggest me

 

Thanks in advance

0 Kudos
1 Solution

Accepted Solutions
Highlighted
Xilinx Employee
Xilinx Employee
6,274 Views
Registered: ‎10-06-2016
Hi @akarshana,

I'm not sure if I am misunderstanding something, but implementing two UARTS in the PL and control them from the PS is really straightforward.

You only have to create a BD where you have two UARTs connected to the AXI bus and then use the xilinx uart drivers as same as the PS integrated UARTs.

Regards
Ibai

Ibai
Don’t forget to reply, kudo, and accept as solution.

View solution in original post

2 Replies
Highlighted
Xilinx Employee
Xilinx Employee
6,275 Views
Registered: ‎10-06-2016
Hi @akarshana,

I'm not sure if I am misunderstanding something, but implementing two UARTS in the PL and control them from the PS is really straightforward.

You only have to create a BD where you have two UARTs connected to the AXI bus and then use the xilinx uart drivers as same as the PS integrated UARTs.

Regards
Ibai

Ibai
Don’t forget to reply, kudo, and accept as solution.

View solution in original post

Adventurer
Adventurer
3,231 Views
Registered: ‎03-06-2015

Is there any reference example for this? if there, please provide me.

0 Kudos