cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Visitor
Visitor
4,350 Views
Registered: ‎05-29-2013

Boot ZC706 from QSPI

Hi! I'm using project is "Restoring ZC706 QSPI Flash" in Vivado 2013.4.

The INIT LED pulses RED, when programming Zynq from QSPI (SW11=00010).

But, Loading QSPI from PC is succeeds.

And JTAG mode (SW=00000) and SD Card (SW=00110) is working normally.

 

What the problem?

0 Kudos
1 Reply
Highlighted
Community Manager
Community Manager
4,266 Views
Registered: ‎07-23-2012

Re: Boot ZC706 from QSPI

Hi,

If the INIT is LOW, the boot won't be successful.

I guess there is some issue with the INIT LED on board. Can you please use impact and read the device status register to confirm the status of INIT pin. If we are seeing the value as 1, then I guess there could be an issue with the LED.
-----------------------------------------------------------------------------------------------
Please mark the post as "Accept as solution" if the information provided answers your query/resolves your issue.

Give Kudos to a post which you think is helpful.
0 Kudos