cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
m.torabi
Contributor
Contributor
388 Views
Registered: ‎07-17-2019

Confused with the interrupt IDs in the user guide and xparameters_ps.h

Jump to solution

Hi,

I found the following interrupt IDs in both user guide (PG201) page 13 and xparamters_ps.h file as shown below. For the pl_ps_irq0 both IDs are the same. However, the pl_ps_irq1 starts from 137 to 144 in the user guide and 136 to 143 in the xparamters_ps.h.

 
/* Shared Peripheral Interrupts (SPI) */
#define XPS_FPGA0_INT_ID		121U
#define XPS_FPGA1_INT_ID		122U
#define XPS_FPGA2_INT_ID		123U
#define XPS_FPGA3_INT_ID		124U
#define XPS_FPGA4_INT_ID		125U
#define XPS_FPGA5_INT_ID		126U
#define XPS_FPGA6_INT_ID		127U
#define XPS_FPGA7_INT_ID		128U
#define XPS_FPGA8_INT_ID		136U
#define XPS_FPGA9_INT_ID		137U
#define XPS_FPGA10_INT_ID		138U
#define XPS_FPGA11_INT_ID		139U
#define XPS_FPGA12_INT_ID		140U
#define XPS_FPGA13_INT_ID		141U
#define XPS_FPGA14_INT_ID		142U
#define XPS_FPGA15_INT_ID		143U

Could you please advise why these two are different? Should I modify xparameters_ps.h?

Thanks

 

Tags (3)
1 Solution

Accepted Solutions
abouassi
Moderator
Moderator
175 Views
Registered: ‎03-25-2019

Hi @m.torabi,

It's a typo that has been corrected on PG201_V3.3.

Best regards,
Abdallah
-------------------------------------------------------------------------------
Please don't forget to reply, kudo and accept as a solution

View solution in original post

Tags (1)
2 Replies
m.torabi
Contributor
Contributor
375 Views
Registered: ‎07-17-2019

I guess this is a typo in Table 2-1 in page 13 of  (PG201), this is version v3.0. In the next page(14)  Table 2-2 of version v3.2 (PG201 V3.2 ), I found the range of interrupt IDs as 121-128,136-143. 

Please check and let me know if this is a typo. 

Thanks 

abouassi
Moderator
Moderator
176 Views
Registered: ‎03-25-2019

Hi @m.torabi,

It's a typo that has been corrected on PG201_V3.3.

Best regards,
Abdallah
-------------------------------------------------------------------------------
Please don't forget to reply, kudo and accept as a solution

View solution in original post

Tags (1)